Wimbledon Greater London, England
TUMC provides competitive prices without compromising on quality. All works are designed, constructed and managed to meet your needs and demands. We know each project is unique and this is shown in every aspect of our service.
Taking time understanding our customers/clients needs and demands is paramount to us.
Show more
3 customer reviews
Simon
Very committed and proffessional and knowledgeable
Curly
Had work completed bt this company, it was breath of fresh air 100% from start to finish.
Thank you TUMC
Mrs T Cornwall
Top team, happy with every point from beginning to end. Very helpful
How can someone tell if their loft is suitable for conversion?
1. Can you stand up in your loft?
A – Yes, there is plenty of head height right across most of the space
B – I can stand upright in the middle and for a step or two either side but then I have to stoop
C – No. I can’t stand anywhere in the loft
2. How much space is there between the purlins (these support the rafters) in your roof?
A – There seems to be a lot of space
B – Not a huge amount but I can imagine there’s enough space for a small room
C – Space is very tight
3. How was your roof made?
A – I think it has a standard timber frame
B – I’m not really sure
C – I think it’s a trussed roof. It looks like there might be some steel up there
1. The roof space is inspected for suitability
An inspection of the inside of the roof space will provide information as to its suitability for conversion. The main features to initially consider include height, access and obstacles. Here, a water storage tank and chimney stacks formed the main obstacles, but the height and pitch suggested that conversion was possible.
2. An architect or surveyor will confirm suitability and create plans
An architect or surveyor will confirm the loft’s suitability for conversion. It is also necessary to take into account whether the building will be adequate to take the added load of a conversion. Following this, plans are drawn which also provide a basis for cost analysis, and what tasks can be done on a DIY basis.
3. The loft is cleared and prepped
Run us through the different stages in the loft conversion process - what’s involved?
With Building Control approval, work can be started by clearing the loft space. In this example the water storage tank was redundant because a new combi boiler was fitted. If this is still required then it will need to be moved to a convenient space to the side. Two chimney stacks were removed.
4. Rewiring is assessed
The electrical wiring and other services that are attached to joists and binders must be removed and rerouted. It provides a good opportunity to replace and improve the original wiring. This requirement is likely to mean that some services may not be available until the new wiring and any pipework can be replaced.
5. New floor joists fitted
The new floor joists can now be fitted. The actual sizes will depend upon the spans, but might typically be 50mm x 220mm C24 or C16 timbers spaced at 400mm intervals. Where there is a window or door opening below this is bridged by doubled-up timber suspended between doubled-up joists. The intermediate joists are attached to the window bridge using joist hangers. New wiring and any required pipework can now be installed.
6. Floors are insulated
The spaces between the joists are filled with insulation to a depth of 100mm. Following Building Control inspection, the joists can be covered with floorboards. The roofing struts and hangers are temporary but securely reinstalled until suitable replacement arrangements are in place.
7. Floorboards laid
The tongue-and-groove chipboard floorboards are held in place with screws. A water-resistant grade is a good choice, and essential in the bath or shower room.
8. Rafters reinforced
Work can now be started in rafter reinforcement in accordance with the structural requirements so that the purlins, struts, and collars can be safely removed. This will open up the area.
9. Dormers installed (if applicable)
Dormers can now be installed. This will involve opening up the roof, so dry weather is desirable to avoid the risk of water damage. The Building Control officer will inspect to ensure that the roof structure reinforcements are as specified.
How long have you been in business?
Over 7 years and about 110 years of experience between project managers.
What guarantee does your work come with?
Materials and Services 2-5 Years
For all our works and never a problem. If something needs repacing no fuss.
What do you love most about your job?
Making people HAPPY and exceeding their expectations.
What inspired you to start your own business?
Love working OUTSIDE OF THE BOX
Been able to take something rundown and, looks like there is little that can be don't, and surprise WoW.
Why should our clients choose you?
We treat every project as it's our own!
We are part of what your dreams are for the project and take you beyond.
And key, Our relationship, we will help lead you.
Full Services
By using us we will take you beyond your OWN ideas. Once a design has been agreed we will endeavor to make use of all the latest aspects of technology and materials to produce the unique and effective project with a sense of individuality, quality and agelessness.
Tanking
Water Proofing System
Basements Complete